Seiko 7C17 Instrukcja Użytkownika Pobierz pdf (Strona 26)

Aug. 17, 07

The L-CAT EVO can be programmed to slide into a terminal to avoid the tip coming into contact with

the terminal in the case that it may be bent. This is accomplished by programming the joint as a slide

solder joint vs. a point solder. The slide solder programming takes two steps per joint. A START step

and an END step. The table & photos below will help illustrate the programming locations and steps.

Step X Y Z Theta Speed WK No. DLY End

Slide Step 01

361.00

130.32 25.3 275.6

250

201

Slide Step 02

361.00

131.32 25.3 275.6

200

~ 1 mm gap

Slide towards terminal

Slide Step 01:

The iron tip should be programmed

approx. 1 mm away from the pin or

on the edge of the pad. This is done

to compensate for any angle that the

pin / terminal may be leaning.

When programming a slide solder

step, you will see a set of brackets

[ ] in the WORK field. These

brackets are for a programmed delay

to allow the solder to start feeding

prior to the tip moving. The table

below shows a delay of 0.3 seconds.

A delay setting of 0.1 ~ 0.3 should

work for your application

The second step of the slide should be

programmed in the normal location that

you would program the tip for point

soldering. The iron tip will move

towards the terminal between steps 01 &

02. You will also need to program a

slide speed. A speed of 5 ~ 15 mm /

second should be programmed to allow

the iron tip to move towards the terminal

at a slow rate of speed to prevent any

damage to the iron tip, terminal or solder

mask. The rate of speed to be

programmed for slide step 01 should be

the normal speed of approx. 250 mm/sec

Slide speed = 5 mm / sec.

Feed delay of 0.3 seconds

Slide solder profile = 201

Slide step 2 programmed

Y location 1 mm closer

End of slide solder sequence is always 200

Slide step 1 programmed Y

location 1 mm from terminal

Slide Step 02:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

Seiko 7C17 Instrukcja Użytkownika Strona 26

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Seiko 7C17