Seiko 7002 Instrukcja Użytkownika Pobierz pdf (Strona 2)

1. PACKING LIST

Before your begin installing your E-1, please make sure, that the following materials

have been shipped:

- 1 E-1 eeprom programmer

- 1 RS-232 “straight-through” serial cable

- 1 3,5” Floppy disk containing the DOS software

- 2 AA size batteries (4 AA size batteries)

- Transport box

Customers who have purchased the optimal 24C01 programming adapter will have an

additional adapter containing 8 pins DIP socket with 2 pull-up resistors.

If any of these items are missing or damaged, please contact us immediately.

2. GENERAL INFORMATION

The E-1 is a hand-held, battery powered serial CMOS eeprom programmer intend for

autonomous operate without PC. Based on the Atmel AT90S8515 micropro cessor, the

E-1 used own EEPROM array, for storage dump contents (1K) in memory E-1, 20x4

character LCD screen with back-light, 4x4 keypad for editor, 4 control buttons, 2

switches (power supply and soft-neon (back-light)). Power consumption ~20-23 mA

(back-light OFF), ~45-52 mA (back-light ON). General dimensions (mm): 148x128x24.

NOTE

Before programming AT24C01A device (or similar), insert into 8 pins Dip socket

programming adapter according with Figure 3.

-2-

This E-1 eeprom programmer is a delicate instrument and treated with care,

will provide years of satisfactory performance. Improper connection of the

E-1 programmer may cause damage to your programmer and/o r your PC.

Use only prescribed type of batteries and cable shipped with complete!

1 2 3 4 5 6 7 ... 10 11

Brak uwag

Seiko 7002 Instrukcja Użytkownika Strona 2